Assembling The Unit - Stihl SR 430 Instruction Manual

Assembling the Unit

Hose and throttle cable, and the
metering unit's operating cable on
the SR 450, come connected
ready for use and must not be
kinked while assembling the
machine.
The combination wrench and
screwdriver are in the supplied
accessory bag.
Fitting the pleated hose on the blower
tube
1 2
N Slide the wide hose clamp (1) onto
the blower tube (2) and line it up.
3 2
4
N Push the ring seal (3) (wide lip
facing left) onto the blower tube (2).
N
Push the pleated hose (4) over the
ring seal (3).
SR 430, SR 450
1
4
5
N Slide the wide hose clamp (1) onto
the pleated hose (4).
N Secure the wide hose clamp (1) with
the screw (5) – the blower tube (2)
must still rotate.
Fitting the pleated hose on the elbow
– SR 430 only
6
7
N Slide the narrow hose clamp (6)
(bezel facing left) onto the elbow
and line it up.
N Push the pleated hose (4) over the
elbow (7).
2
8
N Slide the narrow hose clamp (6)
onto the pleated hose (4).
4
N Secure the hose clamp (6) with the
screw (8) from the side facing the
operator.
Fitting the antistatic system – SR 450
only
N Attach the antistatic wire (1) and
chain (2) to the blower housing with
screw (3).
English
6
4
8
6
3
1
2
9