Zte ZXV10H108L User Manual page 10

Parameter Name
Enable NAT
Enable VLAN
VLAN ID
802.1p
VPI/VCI
New VPI/VCI
Encapsulation Type
Service Type
Username/Password
Authentication Type
Connection Trigger
Idle Timeout
3. Click Create to create connection.
Enable/disable Network Address Translation (NAT). This
function can be configured in route mode only. It cannot
be configured in bridge mode.
Enable/disable VLAN configuration. VLAN ID and 802.1p
are used to define to which VLAN the device belongs
as well as the priority.
VLAN ID of data packets at WAN interface. The value
ranges from 1 to 4094.
Deals with priority, suitable for multiple WAN connections
only. The value ranges from 0 to 7. The default value is
0, which indicates no priority set. The greater the value
is, the higher the priority is.
VPI/VCI (Virtual Path/Channel Identifier) identifies virtual
path and virtual channel of a link.
In the case of first-time configuration, select Create, and
then configure the VPI/VCI values. Otherwise, select a
previously used VPI/VCI values from the drop-down list.
Configures VPI/VCI values, which range from 0 to 255
and from 0 to 65535 respectively. Both of which are
provided by the ISP.
The protocol encryption type, which supports LLC and
VCMUX.
Configuration of ATM QoS which imposes restrictions on
uplink traffic. Four types are available: CBR, RT-VBR,
nRT-VBR and UBR.
Username and password for WAN connection
authentication. Both of which are provided by the ISP.
Authentication protocol type. Options: Auto, PAP and
CHAP. The value is Auto by default.
Connection triggering mode. Options: Always On, On
Demand, and manual. The mode is Always on by default.
The default value is 1200 seconds. It can be set when
the Connection Trigger is set to On Demand only.
9
Description