Zte ZXV10H108L User Manual page 11

4.2.2 WLAN WLAN Configuration WLAN Configuration Configuration
1. Select [Network→WLAN→Basic 11n ] to open the WLAN Basic Parameter page, as
shown in the figure below.
2. Set the parameters according to the description below.
Parameter Name
Enable Wireless RF
Enable Isolation
Mode
Country/Region
Band Width
Channel
SGI Enable
Beacon Interval
Enable/disable WLAN RF.
Enable/disable internal isolation.
Wireless communication mode, including
Mixed (802.11b+802.11g) and Mixed
802.11b+802.11g+802.11n.
Country or region where the device to be used.
Band width to be set. Options: 20MHz and 40MHz.
The value is 20MHz by default. Configurable when
Mixed (802.11b+802.11g+802.11n) is enabled only.
Wireless signal channel. Select from auto and integ
ers from 1 to 13 according to the country code. The
default value is Auto.
Wireless channel used in the communication between
the wireless access point and wireless station, which
channel to use depends on the local administration.
All stations communicating with H108L must use the
same channel.
Enable/disable SGI. Configurable when 802.11n
mode is enabled only.
The default value is 100ms.
10
Description