Ptt Call To All Devices; Answer A Ptt Call - AT&T SynJ SB67108 User Manual

Handset operation
Push to talk (PTT) intercom

PTT call to all devices

1. When the handset is idle:
Press and hold PTT on the side of your handset until
your handset screen shows PTT to: All.
-OR-
Press PTT. Press Press
Press and hold PTT until your handset screen shows
PTT to: All.
When the connection is made, both the caller
and the destination parties hear two beeps. The
speakerphones on all other extensions
automatically activate.
2. Speak into the speakerphone. Your voice is broadcast to all extensions.
3. Release PTT after speaking. There is a three-second PTT wait state
with -MUTE slowly flashing on the screen. During the PTT wait
state, if necessary, you can press and hold the PTT key to continue
speaking into the speakerphone.
4. Any extension can reply (see Answer a PTT call below).

Answer a PTT call

1. When you hear two beeps, the screen displays
PTT from: X:Handset X (X represents the extension
number [1-0]; Handset X represents the default
handset name), PTT from: X:Deskset X
(X represents the extension number [1-0],
Deskset X represents the handset name). or
PTT from: :Base.
*
2. Press INT to convert the call into a normal
intercom call with that extension.
-OR-
Respond with a new PTT call. Wait for the end
of the three-second PTT wait state (the screen
changes to idle mode). To respond with a handset,
see PTT call to a single device or PTT call to
all devices on pages 38-39. To respond with the
telephone base, see Answer a PTT call in the
SynJ SB67138/SB67158 user's manual.
DIR or CID to choose #: All.
40
until
PTT to:
All
Release PTT key
to stop
PTT to:
All
-MUTE
PTT from:
2:Handset 2