Battery Replacement; Operating Instructions - Stanley IntelliLaser Pro Instruction Manual

114C IM 14Aug06
IntelliLaser™ Pro (77-500)
Laser Pod
The addition of the laser pod opens up the functionality
of the stud finder. The unit is mountable using adhesive
pads (included). Retractable feet keep the adhesive
away from the surface during placement. The laser pod
can be tilted ±10° once it is attached to the surface
without removing the adhesive. This allows for easy
repositioning of the laser plane. The laser pod can be set
to level, plumb or any other angle required. With the
laser pod mounted to the wall horizontally, you are free
to use the main stud sensor laser pod and mark both the
height and stud locations at the same time.
The IntelliL L a a s s e e r r ™ ™ P P r r o o laser pod generates a horizontal
or vertical laser plane. It can also be mounted to the wall
to reproduce any angle required.
The IntelliL L a a s s e e r r ™ ™ P P r r o o laser pod provides heavy duty
ABS construction with large rubber pads to provide a
firm grip and superior impact
resistance.

Operating Instructions

Battery Replacement

Open the battery door on back of unit
and connect a 9-volt battery (not
included) to the clip. Place battery into
case and snap battery door in place. It
is recommended that you replace the
battery when the low battery indicator
is lit.
Open the battery door on back of
unit by sliding the door down. Slide
in (2) AAA batteries (not included).
Slide the battery door in place.
8/14/06 7:40 PM
Battery
Door
–3–
Page 4
Battery
Door
ILLUSTRATION 1
ILLUSTRATION 2