114-GB(cover,p1-12) 25/08/2003 10:49 AM Page SAFETY INSTRUCTIONS: Failure to follow warnings may result in bodily injury. The following warnings must be followed to avoid injury: • DO NOT remove warning labels. • DO NOT use optical tools such as a transit to view laser beam.
10:49 AM Page IntelliLaser Pro (77-260) ™ Pro uses electronic signals The Stanley ® IntelliLaser ™ to locate the position of studs, joists or live AC wires through drywall and other common wall materials. Once the edge of the stud has been detected, the...
Operating Instructions Battery Replacement Open the battery door on back of unit and connect a 9-volt battery to clip. Place battery back into case and snap battery door on. Recommend to replace Battery a new 9 volt battery when low battery Door indicator is on.
USAGE Detecting Wood Studs Wood Stud detection is set as the default when the unit is on. 1. Slide the unit across the surface in a straight line. The closer the unit is to the stud the more bars will be shown as illustration 6.
114-GB(cover,p1-12) 25/08/2003 10:49 AM Page Detecting Metal Studs METAL 1. Press “Metal” button once and the LCD as shown in illustration 8. Press & keep holding the “On”button all the time during the ILLUSTRATION 8 stud detection 2. Repeat the procedure 1-5 as described in“Detecting Wood Stud”.
114-GB(cover,p1-12) 25/08/2003 10:49 AM Page Laser Plane Laser aperture Level Vial Level Vial Lock/Release button Level Vial ILLUSTRATION 9 1. Laser plane in the stud detection mode is always on, a laser plane icon is also shown on the LCD. It can be turned off by pressing “Laser” button once.
114-GB(cover,p1-12) 25/08/2003 10:49 AM Page Adjustment Feet ILLUSTRATION 11 The adjustment feet allow the leveling of the Laser line on the horizontal or vertical surfaces. Cautions on Operating You should always use caution when nailing, cutting or drilling in walls, ceilings and floors that may contain wiring or pipes near the surface.
114-GB(cover,p1-12) 25/08/2003 10:49 AM Page Conventional Construction Doors and windows are commonly constructed with additional studs and headers for added Pro detects the edge of stability. The IntelliLaser ™ these double studs and solid headers and emits and holds an audio signal as it crosses over them. Surface Differences Wallpaper—There will be no difference in the function of the stud sensor on surfaces covered...
114-GB(cover,p1-12) 25/08/2003 10:49 AM Page Specifications Utilizing the procedure of scanning and marking Pro will find the stud from two sides, IntelliLaser ™ center with 1/8” accuracy for wood and 1/4” accuracy for metal. When measuring a wood or metal stud, it is recommended the IntelliSensor ™...
Calibration, batteries and maintenance are the responsibility of the user. Where permitted by law, Stanley is not responsible for incidental or consequential damages. Agents of Stanley cannot change this warranty.