Body Shell - Mitsubishi 1993 3000GT Technical Information Manual

4-4

BODY SHELL

HEADLAMP SUPPORT
A structure as shown below is used with the large soft
fascia which consists of the front bumper, skirt panel and
header panel moulded into one unit.
(1) A large and very rigid front end upper bar is used.
Front end upper bar
DASH PANEL
The dash panel is not a double-walled structure
consisting of the dash
reinforcement as in former models but is made
Dash panel
Dash panel crossmember
REAR END PANEL
The rear end panel is mounted on the outside of rear
lamp housings so the panel replacing work becomes
easier.
Rear lamp housing
BODY - Main
panel and dash panel
Muffler hanger reinforcement
Rear end panel
Body
Furthermore, the hood latch bracket has a closed
cross section to improve strength.
(2) A large headlamp housing is used to improve
strength.
30F0064
from a single thick plate. The engine compartment has
effectively expanded while preserving rigidity.
Foot rest bracket
Front floor side sill, inner, front
Front end upper bar
Hood latch bracket
31F0096
Rear lamp housing
Rear end panel
31 F0124
31F0013