Mitsubishi 1993 3000GT Technical Information Manual page 85

DRIVE-CONTROL COMPONENTS -
Damping Force Changeover Actuator
The damping force changeover actuator is built into
the front and rear shock absorbers and designed for
compactness, lightweight and reduction of mounting
space. It is made up of the micro-motor section,
deceleration gear section, position detection switch
Electronic Control Suspension (ECS)
ACTUATOR
ECS Indicator Lamp
There is an indicator lamp (green) to indicate the mode in the
combination meter. When a breakdown is detected, it flashes at
intervals of 0.5 second to warn the driver.
Mode
TOUR lamp
SPORT lamp
12F000
6
TOUR SPORT
ON OFF
OFF ON
section and output shaft. The output shaft has a high
torque output because the high revolutions of the
micro-motor are reduced by the deceleration gear.
Micro-motor
Damping force
changeover
actuator
When breakdown
Flashing
Flashing
Deceleration gear
Position detection
switch
Output shaft
12 F0053
3-13