Table of Contents
Advertisement
Assembly
Step 1
Remove your AeroPilates from its packaging placing the product on its side, with the
LOCKING PIN(29) side upward. Remove the LOCKING PIN(29) and unfold the MAIN
FRAME ASSEMBLY separating the half that has the attached LOCKING PIN(29). When
completed, the frame should be separated approximately 3 feet at the end.
Step 2
Attach the four RUBBER FEET(62) to the FRONT FRAME(1) and REAR FRAME(2) with
ROUND HEAD SCREWS (M5 x 0.8 X 35mm)(38). Attach the WHEELS(27) to the FRONT
FRAME (1) with WASHERS (M8)(47) and NYLOCK NUTS (M8 X 1.25)(42).
Step 3
Unfold your AeroPilates to a flat position by moving the FRONT FRAME(1) away from the
platform end of the product in a clockwise position until fully extended.
6
Advertisement
Table of Contents
