Connecting The Rf Module; Registering The Handset; Handset Layout - RCA H5400 User Manual

Connecting the RF Module

Insert the RF module into the back of the base unit until it snaps into place. The display will show
connected properly.

Registering the Handset

NOTE: Handset must be registered to the base to be operational.
Once a handset is registered it can use the base phone's connection. A cordless handset will not operate until it is registered to a base.
During the registration process, keep the handset near the base.
NOTE: At initial power up, display will show "PLEASE REGISTER". To continue registration from this point, proceed to step #4.
1. On the handset, press the MENU button once, and then press the  button until REGISTRATION shows on the display.
2. Press the SELECT/SAVE button or the STORE button to select Registration mode.
3. Press the  or  button on the handset to select YES.
4. Press SELECT/SAVE to confirm. The display shows REGISTER....
5. On the base, press and hold the PAGE button for 3 seconds. If the registration is successful, the handset will emit a long beep.
6. If the registration fails, FAIL! TRY AGAIN will show on the handset display. Please repeat the above steps.

Handset Layout

Volume Up/Down
(buttons)
Ringer ON/OFF
(switch)
FORMAT/REDIAL
(button)
MENU (button)
DIR (button)
DELETE/CHANNEL
(button)
PRIVACY
(button)
TRANSFER/INT
(button)
CONF (button)
Display
STORE (button)
LINE (button)
TALK (button)
CID (button)
SELECT/SAVE
(button)
HOLD (button)
FLASH/EXIT
(button)
Connections and Setup
when the RF module is
charge cradle with
power supply
charge indicator
5