Setting up the party mode
If you wish to heat and provide DHW (subject to a DHW cylinder being
installed) in the short term and independent of the set heating and time
program.
Press the following keys:
1. !, ? or §; the respective key
will then illuminate.
2. M
for "Party mode"; the party
temperature flashes.
Party mode
3. If you want to change the party
temperature:
a/b for the required
temperature.
4. d
as confirmation; the
temperature no longer
flashes and is now saved.
End party mode
H The party mode ends with the next
automatic change to central
heating at "Standard room
temperature".
H If you want to prematurely
terminate party mode, press the
heating circuit selection key again
and M; the key illumination
extinguishes.
Heating DHW once outside the
programmed periods
H not in heating program "9", and
H The DHW temperature must be
Press the following keys:
20
º C
1. !, ? or §; the respective key
2. M
3. d
4. After approx. 10 seconds, press
Utilising the Comfort function
not during holiday program "j"
below the set value (see page 23).
will then illuminate.
for "Party mode".
to confirm; DHW will be
heated up.
button M again.
13