Rops Model - Kubota M6040 NARROW Workshop Manual

M6040, M7040Narrow, WSM

(2) ROPS Model

Front Axle Rocking Restrictor
1. Install the front axle rocking restrictor (1) (refer to "8. SPECIAL
TOOLS" at "NG. GENERAL" section) to the front axle bracket
on both sides.
(1) Front Axle Rocking Restrictor
Rear Wheel and Fenders
1. Make sure the transmission case and clutch housing case are
securely mounted on the disassembling stands.
2. Remove the rear wheels.
3. Remove the harness cover (1) and disconnect the connectors
(3) and (4).
4. Remove the hydraulic lever guide from fender R.H. and remove
the fenders (2).
(When reassembling)
• Assemble the hydraulic lever guide to original position.
Tightening torque Rear wheel mounting nut
(1) Harness Cover
(2) Fender
Seat
1. Remove the seat (1) with seat stay (3).
2. Remove the rubber sheets (2) and (5).
3. Remove the rubber step (4).
(1) Seat
(2) Rubber Sheet
(3) Seat Stay
N2-S3
CLUTCH
9Y1210220CLS0005US0
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
(3) Connector
(4) Connector
9Y1210220CLS0006US0
(4) Rubber Step
(5) Rubber Sheet
9Y1210220CLS0007US0
KiSC issued 07, 2012 A