M6040, M7040Narrow, WSM
2. DISASSEMBLING AND SERVICING
[1] PREPARATION
Draining Fuel and Transmission Fluid
1. Refer to "2. LUBRICANTS, FUEL AND COOLANT" at "NG.
GENERAL" section.
Lift Rod, Lower Link and Top Link
1. Remove the top link (1).
2. Remove the cotter pin and slotted nut (5).
3. Remove the stabilizer bracket (2).
4. Remove the lift rod (3) with lower link (4).
(When reassembling)
• Tighten the slotted nut (5) by hand and assemble the cotter pin.
Stabilizer bracket mounting
screw (M16, 9T)
Tightening torque
Stabilizer bracket mounting
nut (M16, 7T)
(1) Top Link
(2) Stabilizer Bracket
(3) Lift Rod
Rear Wheel
1. Place the disassembling stand under the transmission case.
2. Install the front axle rocking restrictor (1) to the front axle
bracket on both sides (refer to "8. SPECIAL TOOLS" at "NG.
GENERAL" section).
3. Remove the both rear wheels.
Tightening torque
Rear wheel mounting nut
(1) Front Axle Rocking Restrictor
N4-S2
REAR AXLE
9Y1210220RAS0002US0
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
197 to 225 N·m
20.0 to 23.0 kgf·m
145 to 166 lbf·ft
(4) Lower Link
(5) Slotted Nut
9Y1210220RAS0003US0
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
9Y1210220RAS0004US0
KiSC issued 07, 2012 A