Safety Instructions For Battery Packs; Minimum Gauge For Cord Sets - Black & Decker LSW36 Instruction Manual

Hide thumbs Also See for LSW36:
Table of Contents

Advertisement

Available languages

Available languages

o
o
o
o
o
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
101-150
240V
0-50
51-100
101-200
201-300
Ampere
Rating
More Not more
American Wire Gauge
Than Than
0
6
18
16
16
14
6
10
18
16
14
12
10
-
12
16
16
14
12
12
-
16
14
12
Not Recommended
Do not expose charger to rain or snow.
Pult byplug
rather than cord when disconnecting
charger.
This will reduce risk of damage to electric plug and cord.
Make sure that cord is located so that it will not be stepped
on, tripped
over, or otherwise
subjected
to damage or stress.
Do not use an extension
cord unless it is absolutely
necessary.
Use of improper extension cord could result in risk of
fire, electric shock; or electrocution.
Do not place any object on top of charger or place the charger
on a soft surface that might block the ventilation
slots and
result in excessive
internal heat. Place the charger in a
position away from any heat source.
The charger is ventilated
through slots in the top and the bottom of the housing.
Do not mount charger on wail or permanently
affix charger
to any surface.
The charger is intended to use on a flat, stable
surface (i.e., table top, bench top).
Do not use with damaged cord or plug. If appliance is not working
as it should, has been dropped, damaged, left outdoors, or dropped
into water, return it to a service center.
Do not pull or carry by cord, use cord as a handle, close a door
on cord, or pull cord around sharp edges or corners.
Do not run
appliance over cord. Keep cord away from heated surfaces.
Do not operate charger with damaged
cord or plug = have
them replaced immediately.
Do not operate charger if it has received a sharp blow, been
dropped,
or otherwise
damaged
in any way. Take it to an
authorized service center.
• Do not disassemble
charger;
take it to an authorized service
center when service or repair is required. Incorrect reassembly may
result in a risk of electric shock; electrocution or fire.
• Disconnect
the charger from the outlet before attempting
any
cleaning.
This will reduce the risk of electric shock: Removing the
battery pack will not reduce this risk:
• NEVER attempt to connect
2 chargers
together.
• The charger is designed to operate on standard household electrical
power (120 Volts). Do not attempt to use it on any other voltage.
SAVE THESE
INSTRUCTIONS
ZhWARNING:
For safe operation, read this manual and manuals
originally supplied with tool before using the charger.
The battery pack is not fully charged out of the carton. Before using the battery
pack and charger, read the safety instructions b elow. Then follow charging
procedures outlined.
READ ALL INSTRUCTIONS
. Do not incinerate the battery pack even if it is severely damaged or is
completely worn out. The battery pack can explode in a fire. Toxic fumes
and materials are created when battery packs are burned.
• Do not charge or use battery in explosive atmospheres,
such as
in the presence of flammable
liquids, gases or dust. Inserting or
removing the battery from the charger may ignite the dust or fumes.
. if battery contents come into contact with the skin, immediatelywash
area with mild soap and water. If battery /iquid gets into the eye, rinse water
over the open eye for 15minutes or until irritation ceases. If medical attention
is needed, the battery electrolyte for Li-ion batteries is composed of a mixture
of liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory
irritation.
Provide fresh air. If symptoms persist, seek medical attention.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents