Connecting Gas/Air Supply; Connecting Work Clamp - Miller Spectrum 375 Owner's Manual

4-6. Connecting Gas/Air Supply

Tools Needed:
5/8, 1-1/8 in.
From Gas/Air

4-7. Connecting Work Clamp

2
.
A complete Parts List is available at www.MillerWelds.com
3
2
Supply
4
1
1
.
Use only clean, dry air with 90
to 120 psi (621 to 827 kPa)
pressure.
1 Gas/Air Inlet Opening
2 Hose
3 Teflon Tape
Obtain hose with 1/4 NPT right-
hand thread fitting. Wrap threads
with teflon tape (optional) or apply
pipe sealant, and install fitting in
opening. Route hose to gas/air
supply.
4 Air Filter/Regulator
Adjust gas/air pressure according
to Section 5-1.
802 787-C / Ref. 801 319-C / Ref. 804 486-B
1 Work Clamp
2 Workpiece
Connect work clamp to a clean,
paint-free location on workpiece, as
close to cutting area as possible.
Ref. 803 640-A
OM-255 590 Page 15