Check Points Of Every 50 Hours - Kubota L3540 Workshop Manual

L3540, L4240, L5040, L5240, L5740, WSM

[3] CHECK POINTS OF EVERY 50 HOURS

Checking Wheel Mounting Screws and Nuts Tightening Torque
CAUTION
• Never operate tractor with a loose rim, wheel, or axle.
1. Check wheel screws and nuts regularly especially when new. If
there are loosened, tighten as follows.
Front wheel
mounting
nuts
Front wheel
Tightening torque mounting
nuts
Rear wheel mounting
screws and nuts
(1) Front Wheel Mounting Nut
Checking Engine Start System
(GST/Manual Transmission Model)
CAUTION
• Do not allow anyone near the tractor while testing.
• If the tractor does not pass the test, do not operate the
tractor.
Preparation before testing.
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
Test 1 : Switch for the shuttle shift lever.
1. Sit on operator's seat.
2. Shift the shuttle shift lever to the forward or reverse position.
3. Depress the clutch pedal fully.
4. Disengage the PTO clutch control lever.
5. Turn the key to "START" position.
6. The engine must not crank.
Test 2 : Switch for the PTO clutch control lever.
1. Sit on operator's seat.
2. Engage the PTO clutch control lever.
3. Depress the clutch pedal fully.
4. Shift the shuttle shift lever to the neutral position.
5. Turn the key to "START" position.
6. The engine must not crank.
If it cranks at the test 1 or 2, adjust or replace the related
safety switch.
(1) Shuttle Shift Lever
(2) Clutch Pedal
G-24
G GENERAL
137 N·m
L3540
14 kgf·m
L4240
100 lbf·ft
L5040 185 N·m
L5240 19 kgf·m
L5740 136 lbf·ft
215 N·m
22 kgf·m
166 lbf·ft
(2) Rear Wheel Mounting Screw and
Nut
(3) PTO Clutch Control Lever
W10312010
W1030725
KiSC issued 04, 2010 A