Advertisement
Installation Instructions for Stanley Omnilock Wall Mount Units
Installation Instructions for Stanley Omnilock Wall Mount Units
Planning the installation
3
Install batteries
Four alkaline AA batteries (or two weatherized packs
if installing a weatherized unit) are furnished with
your Omnilock system and must be installed before
proceeding with operation verification and system
installation.
Note: For the Extreme Weatherized model, see
Section 5 on page 5 for instructions and Installation
Template for OM Wall Mount System Extreme
Weatherized Units (T83323) for the mounting
template.
1 Remove the gasket and battery cover from the
rear of the housing assembly as shown in Figure
2.
2 Install batteries with proper polarity as shown in
Figure 3. (For weatherized battery packs, simply
connect the wires from the battery pack to the
circuit board as shown in Figure 4.)
Note: Be sure red and black motor wires are
connected before attempting step 4. Align the wires
together so that the wire colors match.
3 Press and hold the reset button on the circuit
board (as shown in Figure 3) until the green light
on the keypad flashes (about three seconds) then
release the button.
4 If using a remote switch, the wires may be routed
through the circuit board. Route the twisted pair
wires through the access hole and to the terminal
at the top of the unit. (Not available for wireless
units.) See Figure 3.
Note: When properly wired, momentarily pressing
the remote switch will cause the system to cycle and
the event will be recorded in the audit log.
5 Replace the battery cover. See Figure 2. Make
sure that the tabs on the lower edge of the
battery cover are hooked over the edge of the
back plate and secure the cover with the screw.
6 Replace the gasket. See Figure 2. Make sure that it
is inside the edge of the housing.
Housing assembly
Track setting
label
Screw
Figure 2
Terminal
(not available
on wireless
models)
Figure 3
Figure 4
Stanley Omnilock
a Product Group of Stanley Security Solutions, Inc.
AA Batteries
Access hole
Battery cover
Gasket
Installing batteries
Wall Mount System circuit board
Terminal
Installing weatherized batteries
Reset
button
Relay
wire
Reset Button
3
Advertisement
