Stanley Omnilock QAXOM Installation Instructions Manual

Planning The Installation
Contents
These installation instructions describe how to install
your QAXOM Exit Device Lock. Topics covered
include:
Planning the installation...........................................1
Preparing The Trim.......................................................3
Finishing The Installation...........................................6
Site survey
Use the following survey to record information
about the installation site. You need this information
to determine how to prepare the door for the lock.
Door information
Door handing and bevel:
If a handing change is required, see "Set the hand"
on page 2.
Left hand, reverse bevel (LHRB)
Right hand, reverse bevel (RHRB)
Door thickness: 1-3/4 to 3 inches (44 to 75 mm).
Environment information
Side of
Model
door
Standard Outside
Weatherized Outside
Outside
Extreme
Weatherized
Inside
T83325/Rev A ER-7991-12 Jan 2010
Temperature
Exposure
Range
Drip proof.
Inadvertent
+32°F to +129°F
splashing of
0°C to +54°C
water spray
acceptable.
-4°F to +129°F Direct exposure
-20°C to +54°C to rain and snow
-40°F to +129°F Direct exposure
-40°C to + 54°C to rain and snow
+32°F to +129°F
N/A
0°C to +54°C
a Product Group of Stanley Security Solutions, Inc.
Installation Instructions for
Stanley Omnilock QAXOM
Exit Device Locks
Components checklist
Your Stanley Omnilock package comes with the tem-
plate, tailpiece and adapter plate for the model of
exit device being replaced. Use the following check-
list to make sure that you have the items necessary to
install your Stanley QAXOM Exit Device Lock.
Components provided in the box:
Adapter plate and tailpiece
Outside escutcheon assembly
Outside lever and spindle assembly
Installation template and instructions
Screw package
Batteries
3/32 hex driver
Other components:
Programming Default ID Card (provided with
software)
Stanley Omnilock 1