Reassembly - Gilera SATURNO BIALBERO 350 Workshop Manual

FRONT WHEEL 12
Bearing disassembly
Remove the speedometer drive and drive gear dust cover ring (fig. 6).
Remove the wheel bearings and spacer bush from the wheel hub.
Do not reinstall the old bearings; once the bearings are removed, they
must be replaced with new ones.
Bearing reassembly
Fill bearing cavity with grease. Insert first the right bearing and mount the
spacer; insert the left bearing (fig. 7).
Place some grease on the inside of the dust cover and mount it (fig. 8).
Install the speedometer drive gear ring in the wheel hub aligning the tabs
with the slot. Grease the speedometer drive and mount it in the wheel hub
aligning the tabs with the slot (fig. 9).

REASSEMBLY

Place calliper on brake disc, being careful not to damage the pads. Clean
wheel spindle and mount it. There are no spindle thrust or spacer
washers.
Tighten the spindle to the recommended torque, then connect cable to the
speedometer drive.
12 - 2,3