Casting Bar - Sea Eagle FoldCat 375fc Instructions And Owner's Manual

Attach the other two black straps to the fabric portion of
the two rear handles as shown in the stern as shown.

Casting Bar

The 375fc and 440fc casting bar is easy to install, very
stable and folds flat when not in use. As shown in the
steps below, just assemble the pieces, slide the bar over
the underbars and tighten the set screws.
Partially deflate both pontoons and insert the base arm of
the casting bar onto the underbar in the bow.
Extend the crossbar so that it lines up with the undersbars
at the bow as shown above - do not extend the crossbar
for the 375 fc.
Insert the casting bar upright base over the underbars as
shown. Tighten the set screw with wrench provided.
Install the padded covers - Install only the large cover on
the 375fc. Install the 2 small covers on either side the
large cover for the FoldCat 440fc.
8
Now attach the upper
part of the casting
bar to the raised
ends till the snaplock
button locks in place.
You may adjust the
height of the casting
bar to the position
that is comfortable
for you.
To fold the casting
bar, depress the
retainer button on
each of the bases as
shown.