Zone Indications; Programming; How To Enter Program Mode; How To Program - Ness Security Products 5000 SERIES Instruction Manual

ZONE INDICATIONS

******************************************************************************************************
There are 8 Zone indicator lights above the
keypad. In normal operating mode they show
the following states:
.
OFF Zone secured
ON Zone unsecured

HOW TO ENTER PROGRAM MODE

******************************************************************************************************
The program Mode is entered whenever
programming options are to be changed.
IMPORTANT: The Control Panel will
automatically exit the Program Mode if no keys
are pressed within a two minute period.

HOW TO PROGRAM

******************************************************************************************************
Programming the NESS 5000 SERIES 8 zone
Control Panel is achieved via the keypad on the
front. Every time a button is pressed, the panel
responds with a very brief beep in
acknowledgment. Each button is used for
three purposes,
a) to enter a number (eg. 1,2,3),
b) to select a programming option
c) to select a command (eg. ARM).
Note: that programming options can
only be selected whilst in PROGRAM
mode.
Programming of options can be carried out
in any order.
All Programming follows this pattern
Select your option and VIEW the current value
(PROG) (OPTION) (END)
FLASHING FAST Primary alarm ie. indicates the
first zone to become unsecured and cause the
alarm.
FLASHING SLOW Secondary alarm - ie. indicates
those zones that have become unsecured
during the Alarm Reset time.
As explained elsewhere in this manual,
these zone lights are used to indicate other
information in the Memory, Exclude,
Monitor, Installation and Client Program
modes.

PROGRAMMING

TO ENTER PROGRAM MODE, PRESS
(PROG) (MASTER CODE) (END)
The Program light will be illuminated.
The PROG or P button is used in the selection
of PROGRAM mode, and thereafter in the
selection of the option to be programmed.
The END or E button is used in all cases to
signify the end of the button sequence just
pressed.
Visual feedback of the options programmed is
achieved by illuminating the zone indicator
lights or flashing the BATTERY/ MAINS light.
The particular type of indications are described
with the setting of each option in the following
pages.
ENTER the new value(s)
(VALUE) (END)
One long beep indicates an invalid entry.
6