Disarming The Control Panel; Monitor Mode - Ness Security Products 5000 SERIES Instruction Manual

SIREN WARNING At the end of the Exit Time, all zones should be secured. If any are
unsecured, the siren will sound as a warning to indicate that those zones have been
automatically Excluded. For maximum security, you should return, DISARM, check the premises
and then ARM again. Continual warnings could mean that a detector is faulty and may have to
be manually Excluded. If the Auto Exclude option is disabled, the siren will sound
continuously if a zone is unsecured at the end of Exit Time.

DISARMING THE CONTROL PANEL

******************************************************************************************************
Upon entering the protected premises through
a delay zone, the Control Panel responds with
BEEPS AT ONE SECOND INTERVALS as a
reminder to Disarm. You then have your
programmed Entry Delay Time to Disarm the
Panel by either:
a) Entering one of your access codes and END, OR
b) Activating the keyswitch.
If the Panel is not Disarmed by the end of the
Entry Delay Time, an alarm will occur. You may
still enter your code to silence the alarm.
1. ENTER the protected premises via a DELAY ZONE.
2. LISTEN for the beeps coming from the panel.
(CODE) (END)
3. Enter
4. The ARMED light should now be extinguished.
A Continuous beep on entry is a warning that an alarm occurred while the
Control Panel was Armed, the external strobe light (If fitted) will also be
flashing as a reminder.
The 1 second entry beeps (not the continuous warning) can be disabled as a function of the installation options.

MONITOR MODE ******************************************************************************************************

Monitor mode allows you to ARM selected
zones while others are ignored. Typically,
Perimeter zones (doors and windows) can be
Monitored while the occupants are at home.
To select MONITOR mode, either
a) Press 8E, OR
b) If you are using a Remote Keyswitch, first
Arm the Panel (by turning the keyswitch
once), then turn the keyswitch twice within
2 seconds.
The Control Panel will respond with 3 beeps
and the Armed/Monitor indicator will FLASH to
indicate that you are in Monitor mode.
If an alarm does occur in Monitor mode, the zone light will remain flashing as a memory until
If one of your codes is, say, 7676 then to
Disarm, enter
7676 E
If you make a mistake in entering your code,
then you must press E and start again. Three
incorrect entries will cause an alarm.
Monitor mode cannot be selected while in
Program memory or Exclude modes.
To EXIT from monitor mode, either
a) Enter (CODE) E to DISARM, OR
b) Activate the keyswitch momentarily to
DISARM, OR
c) Enter 0E, or 0 (CODE) E, to ARM the
Panel.
NOTE: If an alarm occurs, while in Monitor
mode, silence the alarm by entering
(CODE) E or activate the keyswitch.
you exit Monitor mode.
11