Testing And Troubleshooting; Testing - Ness Security Products 5000 SERIES Instruction Manual

TESTING ******************************************************************************************************

To ensure the integrity of your security system,
it should be checked on a regular basis.
YOU can carry out any of the tests outlined
below or engage a qualified Technician from a
licensed Alarm Company to carry out a more
technical assessment according to Australian
Standards AS.2201.1
9.2 MAINTENANCE (extract AS.22O1.1)
9.2.1 Routine maintenance.
9.2.1.1 General Routine maintenance visits to the
alarmed premises shall be made by an authorised
representative of an alarm company at a minimum
rate of twice per year with no more than 7 months
between visits.
Remember: If your system is connected to a
Central Monitoring station, please advise them
prior to carrying out any of these tests.
SIREN TEST
- Enter 2 E, Siren will sound
- To reset siren Enter (CODE) E.
SYSTEM CHECK
-ARM Panel. 0E or O (CODE) E.
-Wait for exit time to expire - trigger any
Instant zone and the siren should sound, OR
trigger a Delay zone - wait for the entry time to
expire and the siren should sound
- Reset the panel (CODE) E.
TESTING AND TROUBLE SHOOTING
WALK TEST
To check correct operation of all zones
(indicated by a 2 second siren and beeper
warning).
NOTE: Programming described in steps 14 are
normal default values. Therefore these steps
may be bypassed if Monitor mode is not being
used and has not been reprogrammed.
1. Enter Program mode
2. Select Monitor mode 2
3. Set all the zones to Monitor zones.
P 8E 1E 2E 3E 4E 5E 6E 7E 8E.
(Select only those zones whose lights are not lit.)
4. Exit the client Program mode PE
Ensure that all zones are secured and then,
5. Select Monitor mode.
Now move around your premises and
unsecured each detector in turn. The siren will
operate for 2 seconds each time a detector is
unsealed.
When you have tested all detectors, check the
control panel to ensure that all zone indicators
are flashing ie. all zones have been tested.
6. EXIT FROM MONITOR MODE by disarming
the panel.
7. Don't forget to re-program the Monitor
mode type, and Monitor zones back to their
normal settings.
15
P (CODE) E
P 7E 2E
8E.