Gas combination boiler for central heating and hot water production, wall mounted, copper heat exchanger, fan assisted, room sealed, electronic flame ignition and control installation, service and user instructions (52 pages)
Copper wall-mounted combination, gas fired boiler for central heating and domestic hot water production, fan assisted, room sealed compartment, electronic flame ignition and control (49 pages)
Cast aluminium floor standing condensing boilers for natural gas (25 pages)
Summary of Contents for Ferroli F30
Page 1
FERROLI F30 Gas Combination Boiler for Central Heating and Hot Water Production, Wall Mounted, Copper Heat Exchanger, Fan Assisted, Room Sealed, Electronic Flame Ignition and Control REAR FLUE INSTALLATION INSTRUCTIONS G.C. NO: 47-267-32 Supplied By www.heating spares.co Tel. 0161 620 6677...
Page 2
FERROLI F30 For installation (back flue connection): For direct back flue connection it is necessary to use the optional kit Part No 822186, and it is necessary to alter the fan direction inside the boiler. Please Follow the below procedure carefully:...
Page 3
FERROLI F30 Back flue outlet (Diagram 1-9) 3. Gently pull back until wall seal 1. Core drill 127mm hole (5"). 2. Push through the outer flue. is flush with the wall. Fig. 22a Fig. 22b Fig. 22c 6. Cut the outer flue 80mm longer 7.
Page 4
FERROLI F30 Re-attach the fan with the screws (b). Refit wiring connections to fan and air pressure switch tubes ensuring correct orientation. I.E. red tube to air pressure switch connection with red dot (+) and clear tube to air pressure switch connection with no paint marking (-).