Loading Files Using Ftp Through Ethernet Port - H3C S5120-SI Series Installation Manual

3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
You can enter 1 to load the application file.
The procedure of loading an application file is similar to that of loading a Boot ROM file. The difference
lies in that the system displays the prompt of loading the application file rather than the Boot ROM file.
After loading the application file, the switch displays that you should configure the application attribute,
that is, main, backup, or none. Type a specific attribute to complete loading the application file.
Writing flash..................................................................
................Done!
Please input the file attribute (Main/Backup/None) M
Done!
If an application file with a specific attribute already exists when you set a new file with the attribute, the
attribute of the existing file becomes none after the new file becomes effective.

Loading Files Using FTP Through Ethernet Port

Introduction to FTP
The switch can serve as either an FTP server or an FTP client by using its Ethernet port to download the
system application and configuration files. The switch serves as an FTP client in the following
examples.
Loading a Boot ROM file
When loading a Boot ROM file, the switch can serve only as an FTP client.
Complete the following tasks to load a Boot ROM file using FTP through an Ethernet port (For details
about the HyperTerminal, refer to "Setting Terminal Parameters" on page 4-2):
Set up the configuration environment
Run the FTP Server program on the server
Task
5-14
Remarks
Required
Connect the switch to the TFTP server through
an Ethernet port, and to a PC through the
console port. The PC and the TFTP server can
be the same device.
Required