Module removal
Afterfire solenoid lead
Module wire
Figure 7.3
Figure 7.4
Engine model number
1.
Unplug the spark plug.
2.
Remove the blower/air filter housing by following the
steps procedures in Chapter 3: Air Intake System.
3.
Disconnect the module wire that goes to the system
harness. See Figure 7.3.
4.
Remove the module using a 10 mm wrench.
NOTE: The engine model number is on the module. When
installing a new module, make sure the model
numbers match. See Figure 7.4.
Ignition System
75