MTD P90 series Shop Manual page 71

Bushing is flush with casting
Figure 6.27
positive brushes/cable stud assembly
Seal
Figure 6.28
Figure 6.29
11. Press a new bushing into the end cap until it is flush
12. Insert the seal into the end cap from the inside.
13. Install the positive brushes/cable stud assembly.
14. Install the insulator washer. See Figure 6.28.
15. Install the flat washer against the insulator washer.
16. Install the lock washer.
17. Install the nut that retains the positive brushes/cable
Insulator washer
Brush holder
18. Install the brush holder.
19. Insert the springs in the brush holder.
20. Install the negative brushes.
NOTE: The screws that anchor the negative brushes also
Negative brush
Starter and Charging System
with the casting. See Figure 6.27.
stud assembly.
anchor the brush holder. See Figure 6.29.
65