Manual Two-Key Download Sequence; Manual Three-Key Download Sequence - Printronix T8000 Administrator's Manual

Manual Two-Key Download Sequence

NOTE:
This download method can be completed with firmware in the form of FILENAME.prg or
FILENAME.exe.
The following steps prepare the printer for download. When the printer is in the download mode, any host
IO can be used to download the firmware.
1. Set the printer power switch to O (Off).
2. Connect the Ethernet cable to the printer interface.
3. Press and hold down the LEFT SOFT KEY + RIGHT SOFT KEY on the printer's control panel.
4. Set the printer power switch to I (On).
5. After five seconds, release the front panel keys.
The printer must power-up so this may take to 1-2 minutes. Wait until "PROGRAM DOWNLOAD"
displays on the screen before proceeding.
6. Start a Windows Command Prompt session.
7. Navigate to the directory with the target firmware (e.g., c:\download).
8. Send the firmware to the printer as described for various host IO options:
•
Sending Firmware via Ethernet (LPR) on page 205
•
Sending Firmware via USB on page 205
•
Sending Firmware via Parallel on page 206
•
Sending Firmware via Serial on page 207

Manual Three-Key Download Sequence

If the flash memory contains only boot code (e.g., if it is new), or if flash memory is corrupt, or you want to
delete all Flash User Files, you must download software using the manual three-key download method.
There are two different methods available:
•
With the USB and firmware in the form FILENAME.exe or FILENAME.prg.
•
With the SD card and firmware FILENAME.prg renamed to "UPGRADE" in the SD card root
directory.
1. Set the printer power switch to O (Off).
2. For the USB method, connect the USB cable to the printer interface.
3. For the SD card method, copy FILENAME.prg to "UPGRADE" (no extension) into the SD card root
directory and place into the SD card slot.
4. Press and hold down the LEFT SOFT KEY, RIGHT SOFT KEY, and DOWN ARROW panel keys.
5. Set the printer power switch to I (On).
6. After five seconds, release the control panel keys.
7. The printer must power-up so this may take up to 1-2 minutes. Wait until "DOWNLOAD MODE"
displays on the screen before proceeding.
8. For the SD card method, the downloading process will automatically begin. Wait until it completes and
the printer is fully rebooted with the new firmware. Then remove the SD card – this completes the
process.
9. For the USB method, start a Windows Command Prompt session.
204