System > Energy Star - Printronix T8000 Administrator's Manual

Normally, to lock or unlock the printer menu, the up/down keys are pressed
at the same time. The Set Lock Key executable menu lets you choose dif-
ferent keys to lock or unlock the printer menu. You may choose almost any
group of keys as the new lock and unlock keys. You cannot use the EN-
TER key or any key combinations which are already used for other func-
tions. One or more keys can used simultaneously.
Start
Completed
IM-
PORTANT
System > Energy Star
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode. When you enter into Power
Saver mode, the panel backlight is dimmed, the engine shuts down, and a
panel message informs the user.
Pressing any Control Panel key or certain network access to the printer re-
moves the Power Saver message from the panel and the turns on the backlight
(but the engine is still shut down). Sending a print job to the printer results in a
full exit of Power Saver mode.
Selections
Factory Default
IM-
PORTANT
System > Control > Set Lock Key
The ENTER key is used to start the sequence and
the user will be asked to select a new lock key.
After following all the instructions on the front panel
(including entering the new lock key twice to confirm),
the user will be informed the process was completed.
If not successful, then the user will alerted.
The new lock combination will remain even if the
printer is powered off and back on.
System > Energy Star > Pwr Saver Time
The options are 1, 5, 10, 15, 30, 45, 60, and 240
minutes.
5 minutes.
When ODV is installed and enabled, about 20 sec-
onds is required to re-initialize ODV. During the
Power Saver exiting procedure, a message will be
displayed alerting user of the required delay.
93