Troubleshooting - KTM 2014 1290 Super Duke R EU Owner's Manual

22

TROUBLESHOOTING

Faults
The combination instrument shows
nothing on the display
The engine does not crank when the
electric starter button is pressed
The engine only turns if the clutch
lever is drawn
The engine turns although a gear is
engaged
The engine turns but does not start
Possible cause
Fuse 1 is blown
The main fuse is blown
The battery is discharged
The ignition/steering lock is faulty
The emergency OFF switch is off
Operating error
The battery is discharged
The safety start system is faulty
CAN bus communication error
Fault in EFI control unit.
Fault in the MCU control unit.
The vehicle is in gear
The safety start system is faulty
The safety start system is faulty
The coupling of the fuel hose connec-
tion is not connected
Action
–
Change the fuses in the fuse box. (
–
Change the main fuse. (
–
Recharge the battery.
x
–
Check the open-circuit current.
–
Check the ignition/steering lock.
–
Press the emergency OFF switch to the posi-
tion ON .
–
Carry out the start procedure. (
–
Recharge the battery. x
–
Check the open-circuit current.
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Shift the transmission to idle
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Reconnect the coupling of the fuel hose connec-
tion.
169
p. 138)
p. 135)
( p. 131)
x
x
p. 67)
( p. 131)
x
.