Table of Contents
Advertisement
INSTALL THE SAW ON A STABLE SURFACE
The unit should be installed on a flat, sturdy and stable
surface able to support the weight of the machine and
the workpiece with ease.
ATTACHING THE LEVELING FEET
Install the leveling feet as shown. Loosen the upper A
and lower B nuts as needed to adjust the height of the
foot.
FOR YOUR SAFETY IT IS ESSENTIAL THAT THE MACHINE DOES NOT ROCK OR TIP DURING OPERATION. UPON START-
UP OR DURING OPERATION, IF YOU NOTICE ANY ROCKING, TIPPING OR CHATTERING OF THE BASE TURN THE
MACHINE OFF IMMEDIATELY AND READJUST THE LEVELING FEET AS NEEDED TO STABILIZE THE SCROLL SAW ON THE
BENCH OR WORK SURFACE
MOUNTING TO A WORK SURFACE
If a permanent shop placement is practical, consider
removing the leveling feet on the base and drilling
matching through holes in the mounting surface of your
workbench or stand to bolt the saw in place (hardware
not included) on your workbench.
If a permanent installation is not practical, clamps can
also be used to secure the saw to a bench or work
table.
10
Never install the machine over the edge of a table or
workbench.
INSTALLING THE OPTIONAL STAND
A
B
If you prefer, an optional stand (item EX-21BS for EX-16
CE & EX-21CE or item EX-30BS for EX-30CE) is available
from your local General International dealer. The
stand is equipped with mounting holes allowing the
saw, after removing the leveling feet, to be bolted
directly to the stand.
A
E
B
ORDER OF ASSEMBLY
A- Saw
C
B- Hex head bolt
C- Flat washer
D
D- Workbench or stand
E- Flat washer
F- Lock washer
F
G- Hex nut
G
Hide quick links:
Advertisement
Table of Contents
