Additional Information; Troubleshooting; Error Messages; Additional Information Troubleshooting - Pioneer AXM-P7050 Operation Manual

Additional Information

Troubleshooting

Common
Symptom
Power doesnt turn on.
The unit doesnt operate.
Operation with the remote con-
trol isnt possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
No sounds are heard.
The volume level will not rise.
Theres no sound.
Volume level is low.

Error messages

When problems occur with disc playback, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest PIONEER Service Center.
Error messages
Message
ERROR-02
TEMP
ERROR-10
NON PLAY
Cause
Leads and connectors are incor-
rectly connected.
The fuse is blown.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
The remote control operation mode
is incorrect.
The remote control code is incor-
rect.
Battery power is low.
Cables are not connected correctly.
The volume level is low.
The attenuator is on.
Cause
Dirty disc
Scratched disc
The temperature of this unit is out-
side of the normal operating range
The disc does not have the same re-
gion number as this unit
This type of disc cannot be played
by this unit
The disc is loaded upside down
Action (See)
Confirm once more that all connections are
correct.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rate.
Turn the unit off and then on.
Switch to the correct remote control mode.
(Page 5)
Make sure the remote control selection
switch setting and code type setting are the
same. (Page 32)
Load new battery. (Page 5)
Connect the cables correctly.
Adjust the volume level.
Turn the attenuator off.
Action (See)
Clean disc.
Replace disc.
Wait until the units temperature returns to
within normal operating limits.
Replace the DVD video with one bearing the
correct region number.
Replace the disc with one this unit can play.
Check that the disc is loaded correctly.
Appendix
33
En