Power doesnt turn on.
The unit doesnt operate.
Operation with the remote con-
trol isnt possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
No sounds are heard.
The volume level will not rise.
There is no sound.
Volume level is low.
When problems occur with disc playback, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest PIONEER Service Center.
Leads and connectors are incor-
The fuse is blown.
Noise and other factors are causing
the built-in microprocessor to oper-
The remote control operation mode
The remote control code is incor-
Battery power is low.
Cables are not connected correctly.
The volume level is low.
The attenuator is on.
The temperature of this unit is out-
side the normal operating range
The disc does not have the same re-
gion number as this unit
This type of disc cannot be played
by this unit
The disc is loaded upside down
Confirm once more that all connections are
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rating.
Turn the unit off and then on.
Switch to the correct remote control mode.
Make sure the remote control selection
switch setting and code type setting are the
same. (Page 37)
Load new battery. (Page 5)
Connect the cables correctly.
Adjust the volume level.
Turn the attenuator off.
Wait until the units temperature returns to
within normal operating limits.
Replace the DVD video with one bearing the
correct region number.
Replace the disc with one this unit can play.
Check that the disc is loaded correctly.