Crank Removal - Vision Fitness U70-02 Service Manual

5.10 Crank Removal

NOTE: A special tool is needed to correctly replace a crank. Order part: # 022696-00 from Vision Customer Tech Support.
1) Assemble the special tool as shown in Figure A. The two sides are different on the tool.
2) Remove the crank arm cover (Figure B).
#1
Tool number: 022696-00
Figure A
3) Attach the #1 side of the tool into the crank and use a wrench to remove the nut from the crank (Figure C).
4) Thread the #2 side of tool into the crank. Then turn it at least 7 full revolutions until it is close into the crank (Figure D).
FIGURE C
5) Turn the #1 side of the tool to pull off the crank (Figures E & F).
FIGURE E
CHAPTER 5: PART REPLACEMENT GUIDE
#2
#1
Figure B
#2
FIGURE D
FIGURE F
28