Calibrating The Screen; Checking Battery Status; Attaching The Handstrap - Motorola MC50 User Manual

Calibrating the Screen

To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its storage silo on the back of the mobile computer.
1.
Tap the Windows Mobile screen.
2.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the screen.
3.
Repeat as the target moves around the screen, then tap the screen to continue.
4.

Checking Battery Status

To check whether the main battery or backup battery in the mobile computer is charged, tap
tab >
System Power
To save battery power, set the mobile computer to turn off after a specified number of minutes.

Attaching the Handstrap

The mobile computer has a handstrap which increases comfort when holding the mobile computer for
extended periods of time. To attach the handstrap:
Feed the loop through the handstrap tether.
1.
Feed the other end of the handstrap through the loop.
2.
Pull the handstrap until the loop is secure.
3.
Connect the other end of the handstrap to the handstrap clip at the bottom of the mobile computer.
4.
Handstrap Clip
Handstrap Installation
Figure 1-6
icon to display the window.
Power
Getting Started 1 - 7
> >
Start Settings