Using The Cam; Calibrating The Battery; Starting The Mobile Computer - Motorola MC50 User Manual

1 - 6 MC50 with Windows Mobile 5.0 User Guide
The standard battery fully charges in approximately 3.5 hours and the extended capacity battery fully charges
in approximately seven hours. See

Using the CAM

To charge the mobile computer's battery using the CAM:
Attach the CAM to the bottom of the mobile computer.
1.
Plug the power connector into the power port, and the other end to a power source.
2.
Power Supply
Charging using the CAM
Figure 1-5
The standard battery fully charges in approximately 3.5 hours and the extended capacity battery fully charges
in approximately seven hours. See

Calibrating the Battery

The MC50 battery requires periodic calibration to maintain an accurate calibration of the battery's gas gauge.
To calibrate the battery, deplete the battery completely from a full charge condition. Motorola recommends
performing this once a week.

Starting the Mobile Computer

Press the Power button to turn on the mobile computer. If the mobile computer does not power on, perform a
hard reset. See Resetting the Mobile Computer on page
When turning the mobile computer on for the first time, the mobile computer initializes its Flash File system, the
splash screen displays for about a minute followed by the calibration window. Note that the calibration screen
only appears after a cold boot (hard reset).
Table 1-2 on page 1-5 for mobile computer charging indications.
Table 1-2 on page 1-5 for mobile computer charging indications.
2-19.
CAM