Lamps - BMW 2012 R 1200 GS Rider's Manual

Push two mounts 2 far enough
apart that front suspension fits
between them.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 2 so that
front suspension rests securely
on them.
Tighten adjusting screws 1.
If the motorcycle is resting
on the center stand: The
motorcycle is raised too far at the
front, the center stand lifts off the
ground and the motorcycle can
tip over to the side.
When raising the motorcycle,
make sure that the center stand
remains on the ground.
Apply uniform pressure to push
front wheel stand down and
raise motorcycle.

Lamps

Replacing low-beam and
high-beam bulbs
The alignment of the
connector, the spring
strap and the bulb may differ
from that shown in the following
illustrations.
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Turn counterclockwise to re-
move the cover for the high
8
113
z