Removing The Roll Paper - Epson SC-F6200 Series User Manual

SC-F6200 Series/SC-F6000 Series
Buttons that are used in the following settings
Cutting paper manually using the built-in cutter
A
Press the )button. Viewing the interior of the
printer without opening the printer cover, press
the d button to align the cut location with the
mark on the right side of the printer's
interior.
Note:
The minimum length of paper that can be cut with
the built-in cutter is fixed at 60 to 127 mm and
cannot be changed. If the cutting position is shorter
than the shortest length above, the paper has to be
automatically fed to that length thus a margin will
have to be left. Cut off the margin with a cutter sold
at a store.
B
Press the Zbutton.
The paper is cut by the built-in cutter.
User's Guide
Basic Operations

Removing the roll paper

This section describes how to remove and store roll
paper after printing. The pressure rollers may leave
impressions on paper that is left in the printer.
Buttons that are used in the following settings
A
B
C
28
Confirm that the printer is ready and press the
( button.
The Load/Remove Paper menu will be displayed.
Press the d/u buttons to highlightRemove
Paper and press the Z button.
Note:
To perform Roll Paper Remaining, you must enter
the length of the roll paper when the roll paper is set.
In order to perform accurate remaining roll paper
management, we recommend opening the . tab
and recording the amount of roll paper remaining
when you replace the roll paper.
The paper will automatically be rewound.
Once the paper is rewound, the printer will
display Press and load paper.
Note:
When the display shows Turn roll paper adapter
to wind up roll paper, rewind the paper by hand.