Start-Stop Switch; Use Of Hand Straps; Vibration Training Parameters - Fitvibe smart User Manual

Free Modus
In this menu one can start the vibrations immediately with the preset parameters by
clicking the start/ stop button (7). With the button arrow UP (8) and DOWN (10) the
user is also able to change time and training intensity.
While the active time is running down, a time screen with extra large figures is
displayed (active time display).
Whilst training training intensity can be changed with the button arrow DOWN (10)
When the time is stopped (with the start/ stop button) one can always return to the
parameter menu via a long press on the OK button.

3.4.4 Start-stop switch

The "fitvibe smart" vibration device has been equipped with two start-stop switches.
Both are capable of starting and stopping the vibration independently from one
another:
0ne orange-coloured start-stop button (7) are located on the control unit;
the remote control (22) is connected by cable with the control unit.

3.4.5 Use of hand straps.

Straps can be used to transfer the vibration to certain sections of the body as shown
in the illustration. The non-elastic straps serve to convey the vibrations to the
muscles in question. The straps can be fastened to the vibration plate at the fitting
for straps (20). The straps have been provided with reference lines in different
colours, allowing the user to adjust the length of one strap to the length of the other.

3.4.6 Vibration training parameters

Vibration frequency:
Intensity (amplitude):
Active time:
Operating modes:
14
Fitvibe SMART
30 – 35 - 40 Hz
high / low
0 - 180 sec
Relax & Massage
Upper body training
Lower body training
Streching
Body Shaping
Free Mode
(4 performance levels)
(" "
(" "
(" "
(" "
")
")
")
")