Table of Contents
Related Manuals for Dogtra 180NCP
Summary of Contents for Dogtra 180NCP
- Page 1 REMOTE CONTROLLED DOG TRAINING COLLARS OWNER’S MANUAL 1250 E. 223rd Street, Suite 119 Carson, CA 90745 Tel :(310) 522 -1800 Fax :(310) 522 - 1805 Toll Free :1-888 - 811-9111 2006- ② Copyright c 2006 Dogtra Company www.dogtra.com...
-
Page 2: Table Of Contents
CONTENTS • MAIN FEATURES • PRODUCT SAFETY AND HEALTH STATEMENTS • COLLAR PACKAGE CONTENTS • DESCRIPTION OF TRANSMITTER PARTS • DESCRIPTION OF COLLAR / RECEIVER PARTS • BATTERY CHARGER • CHARGING THE BATTERIES • TESTING YOUR COLLAR • OPERATING INSTRUCTIONS •... -
Page 3: Main Features
ƒU Dogs should be in good health during any e-collar training. Dogtra e-collars are not intended for use on range of 400+ yards. dogs weighing less than 12 pounds or under 6 months of age. -
Page 4: Collar Package Contents
PACKAGE CONTENTS purpose of behavior modification of dogs. They are not intended for human use or use on other animals. Dogtra Company does not assume any liability for Transmitter ƒU improper use of the Dogtra e-collar. -
Page 5: Description Of Transmitter Parts
TRANSMITTER TRANSMITTER DESCRIPTION OF TRANSMITTER PARTS transmitter 2″ Antenna Antenna Transmitter Antenna Intensity A short 2” antenna is supplied with the Selection Dial transmitter. Indicator Light The antenna should be screwed into the top of the transmitter to ensure that the signals are sent properly to the collar receiver and that maximum “Nick”... - Page 6 TRANSMITTER TRANSMITTER Intensity Selection Dial Transmitter Charging Receptacle Transmitter Battery Charging Receptacle Located on the side of the transmitter, the receptacle is covered by a rubber plug. Insert one end of the battery charging cable into the receptacle to charge the battery. (See Battery Charging Procedure on page 21.) Intensity Selection Dial After charging is completed, cover the...
-
Page 7: Button Function
TRANSMITTER BUTTON FUNCTION BUTTON FUNCTION Pager Nick Constant Transmitter Indicator Light (LED window) The transmitter indicator light is located near the intensity selection dial. When a button on the transmitter is pushed, the light comes on to The transmitter for indicate that the transmitter is being activated. -
Page 8: Description Of Collar / Receiver Parts
BUTTON FUNCTION COLLAR / RECEIVER “Nick” Button DESCRIPTION OF COLLAR / RECEIVER PARTS When the “Nick” button is pushed the receiver emits a single, rapid pulse of electrical Collar stimulation. “Constant” Button Pressing the “Constant” button gives continuous stimulation as long as the button is Collar strap Battery pushed, for up to twelve seconds. - Page 9 COLLAR / RECEIVER COLLAR / RECEIVER On/Off Magnetic Switch On/Off Magnetic Switch Receiver Indicator Light (LED window) To activate the Located on the front of the collar, the place the red dot on the back of the transmitter to indicator light comes on and blinks once every 2 the red dot on the collar receiver.
- Page 10 COLLAR / RECEIVER COLLAR / RECEIVER Receiver Charging Receptacle Fitting the Collar on the Dog Receiver Battery Charging Receptacle The collar should be fitted so that the On the inside of the collar receiver, next to stainless steel contact points press firmly against the collar strap, is a battery charging receptacle the dog’s skin.
-
Page 11: Battery Charger
BATTERY CHARGER CHARGING THE BATTERIES BATTERY CHARGER CHARGING THE BATTERIES Charging Cable 120 volt Charger Wall Outlet uses Ni-MH (Nickel-Metal- The battery charger and charging cables allow Hydride) batteries that do not set a memory and you to charge both the transmitter and receiver at can be charged on a regular basis without harm to the same time. - Page 12 CHARGING THE BATTERIES CHARGING THE BATTERIES 2. Do not charge the batteries near any Battery Charging Procedure flammable substances. 1. Attach the charging cables to both the transmitter and receiver(s), as shown on 3. Fully charge the batteries for 14 hours if page 19.
-
Page 13: Testing Your
TESTING TESTING TESTING YOUR 2. Turn the intensity level on the transmitter up to the maximum level (100) and press the Nick button. The indicator light(LED) COLLAR on the collar receiver will light briefly as you push the button. Pressing the Constant button will light the indicator for as long as you hold the button down, up to twelve seconds. -
Page 14: Operating Instructions
OPERATING OPERATING OPERATING INSTRUCTIONS Intensity Selection Fitting the Collar To select the intensity level, start on the zero (0) setting. Gradually increase the level until you The collar strap should be adjusted so that the get a response from the dog that would be contact points are held firmly against the dog’s equivalent to a quick pull or jerk with a leash. - Page 15 OPERATING RECEPTION Maintenance Reception The receiver and collar strap should be e-collar cleaned periodically with detergent and water to has a range of 400+ yards. Depending on the way prevent malfunction. you use your transmitter, the transmitting range may vary. Hold the transmitter away from your Always clean and rinse the collar thoroughly body and avoid touching the antenna to get the with tap water after use in salt water.
-
Page 16: Accessories
Dec. 31, 2005. Fill out the warranty registration card that came with your Dogtra unit and mail it in along with a copy of your receipt within 30 days of purchase. Or, you can register your product online at... - Page 17 Dogtra Co. within the continental United States. Any expedited shipping service Dogtra’s warranty DOES NOT cover repairs will be at the owner’s expense. Dogtra is not or replacement due to misuse, improper responsible for loss of training time or maintenance or lost units.
- Page 18 WARRANTY number. Or, you can visit our web site at www.dogtra.com to fill out a Service Request Form. If repair costs are not covered under warranty, we will call you for credit card information once the work has been completed.
Need help?
Do you have a question about the 180NCP and is the answer not in the manual?
Questions and answers