Table of Contents
Advertisement
The temperature of the liquid used must not
be below 4 °C or above 35 °C.
Sand and other abrasive substances in the
liquid cause increased wear and reduce the
output of the pump.
3. Initial Operation
Starting up the pump :
1
2
RP 240
RP 300
RP 420
RP 600
3
18
Please observe the local noise prevention
regulations.
1. RP 600 : Insert the fountain socket
2. Install the pump at ground level so that the filter housing
is standing in water to at least half its height (with pumps
RP 240 / RP 300 / RP 420 make sure that the sides of the
foam filter under the pump are not blocked).
3. Plug mains plug into an AC power socket.
Warning : Pump will start immediately.
4. Use the flow control
fountain pump.
1
and nozzle tube
3
to set the desired water flow for the
2
.
Advertisement
Table of Contents
