Menu Function Introduction And Setting; Emergency Alarm; Setting Reverse Frequency Function; Scanning - Midland CT 710 Instruction Manual

Menu Function introduction and setting

Emergency Alarm

There are two types of alarms:
1. Press flank key 2
emergency alarm and will send out, at the same time, the alarm sound
and ANI to your partner (if programmed). The alarm stays active till
the PTT is pressed.
2 By means of the programming software, an emergency channel can
be specially set. To activate it, press briefly
on the selected emergency frequency. To exit, press VFO/MR.

Setting Reverse Frequency Function

In channel/Frequency mode, hold down
appears. When "REV"
function is enabled. To deactivate this function, hold down
seconds.

Scanning

The Scan version is very useful to monitor the channels before transmit-
ting.

Select scan type

Press MENU and rotate the encoder to item 13, the screen will display
"013
SCANS?".
Press ENTER: now you are into the scanning mode selection.
You have three types of scanning to choose amongst: TO, CO, SE.
Time-operated scan (TO)
When the radio detects a signal it will stop scanning; the status will re-
main about 5 seconds but the radio will continue to scan even if the si-
gnal is still there.
Carrier-operated scan (CO)
The radio will stop scanning when detects a signal and remains on the
same frequency until the signal is missing.
Search Scan (SE)
When the radio detects a signal, it remains on that channel and stop
18 |
and flank key 1 at the same time: the radio will go to
is displayed on the LCD, the Reverse frequency
# T/R: now you can transmit
# for two seconds until
CT710 Instruction Guide
"T*R?"
# for two