Dtmf Programmed By Software; Ani Ptt-Id Operation - Midland CT 710 Instruction Manual

Vhf/uhf

Hide thumbs Also See for CT 710:

Table of Contents

ENTER

DTMF programmed by software

(see the instructions of the Programming software)

Once the optional call signaling DTMF function is programmed on the

desired channels, press the

Now you can input the 8-digit DTMF codes.

If the input number is wrong and you want to change it, rotate the en-

coder.

Counterclockwise rotation delete one by one, clockwise to exit the DTMF

function. Input your desired number, press

your partner receives the correct code, the programmed DTMF function

or the radio identification will be done.

ANI means Automatic Numbering Identification.

You can set an automatic number identifier visible from the radio's di-

splay of your partner each time you send a call signal. This function must

be activated on both radios and must be programmed by software (see

the instructions of the Programming software).

CT710 Instruction Guide

→

VFO/MR

→

Tasto laterale 2

flank key2

and the display will show DTMF.

→

PTT

key to make a call. When

| 13

Table of Contents