Stove Installation; Installation Preparation; Items Required For Installation; Packing Lists - Travis Industries Spirit DV Owner's Manual

S
TOVE
P 6
AGE

Installation Preparation

! Failure to follow all of the requirements may result in property damage, bodily injury, or even
death.
! This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI
Z223.1 and NFPA 54(88).
! In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4 and Gas-
Equipped Recreational Vehicles and Mobile Housing. This appliance may be installed in
Manufactured Housing only after the home is site located.
! This appliance is designed to operate on natural gas, or propane (LP).
! All exhaust gases must be vented outside the structure of the living-area. Combustion air is
drawn from outside the living-area structure.
! Notify your insurance company before hooking up this fireplace.
! The requirements listed below are divided into sections. All requirements must be met
simultaneously.
Items Packed with the Heater
¥ Lopi Spirit DV Gas Heater
¥ Log Set (2 Logs, 2 Twigs, Coals)
¥ Owner's Manual
Additional Items Required for Stove Installation
¥ Brass or Black Door Frame
¥ Brass, Black, or Cast Legs or Pedestal

Order of Installation

1 If the heater is to use propane, follow the instructions on pages 32 - 38.
2 Attach the legs or pedestal (see page 28) and optional equipment (if applicable)
3 Position the heater (measure clearances from the upper top), use floor protection if needed
4 Connect the gas line
5 Connect the gas vent
6 Follow the instructions under "Finalizing the Installation" on pages 14 through 17.
Stove Clearances
10" Min.
+ Clearances may be reduced by methods specified in NFPA 211, listed wall shields, pipe shields, or
other means approved by local building or fire officials.
I
NSTALLATION
Straight Installations
When installed with this
clearance, the vent is
5-1/2" from the back wall,
18-3/4" from the side wall.
-
For qualified installers only!
¥ Door Kit (Door handle, mounting angle, T-nut)
¥ Propane Conversion Kit
¥ Gas Inlet (3/8" pipe)
¥ Simpson Duravent, Silicone (see page 8 for part #'s)
When installed with this clearance,
the vent is 12" from the wall.
4" Min.
Corner Installations
4" Min.
45¡