Installation Options; Features; Heating Specifications; Dimensions - Travis Industries Spirit DV Owner's Manual

Installation Options:

¥ Freestanding
¥ Residential or Mobile Home
¥ Horizontal or Vertical Vent
¥ Class A Chimney Retrofit

Heating Specifications:

Approximate Heating Capacity (in square feet)*
High Burn Input Rate (In BTU's)
Low Burn Input Rate (In BTU's)
Efficiency**
AFUE (Annual Fuel Utilization Efficiency)
* Heating capacity will vary with the home's floor plan and insulation, natural gas or Propane BTU rating, and outside temperature.
** Efficiency rating is a product of thermal efficiency rating determined under continuous operation independent of installed system.
To measure the net BTU's, multiply the BTU input by the efficiency percentage.

Dimensions

The starter section
is 4-1/8" below the
upper top.
Measure Clearances
from the Upper Top

Fuel:

Emissions:

Electrical Specifications:

F
EATURES AND

Features:

¥ Works During Power Outages
(millivolt system)
¥ High Efficiency; Up to 80% for Natural Gas,
82% for LP (Steady State)
¥ Optional Thermostat or Remote Control
¥ Realistic "Wood Fire" Look
¥ Convenient Operating Controls
¥ Variable-Rate Heat Output
¥ Quiet Blower for Effective Heat Distribution
¥ Low Maintenance
24"
4-7/8"
18-3/4"
The heater is designed either for natural gas or for propane (but not
for both). Check the sticker on the top of the gas control valve.
This unit has passed the ANSI emission standards for vented room
heaters as tested by OMNI Environmental Services, Inc.
120 Volts, 1.3 Amps, 60 Hz (150 watts on high)
S
PECIFICATIONS
Natural Gas
600 - 1600
38,500
18,700
81 %
72.4 %
Weight: 205 Lbs.
Pedestal: 34-7/8"
Brass, Cast Legs: 30-7/8"
Black Legs: 29-1/2"
P 5
AGE
LP (Propane)
600 - 1600
36,500
18,000
81.5 %
73 %