Addendum; Altitude Considerations - Travis Industries Spirit DV Owner's Manual

A
DDENDUM
P 34
AGE
ADDENDUM #1 Altitude Considerations
This fireplace has been tested at altitudes ranging from sea level to 8,000 feet. In this testing we
have found that the fireplace, with its standard orifice, burns correctly with just an air shutter
adjustment. For information on adjusting the air shutter see page 17 of this manual.
! Failure to adjust the air shutter properly may lead to improper combustion which can create a
safety hazard. Please consult your dealer or installer if you suspect an improperly adjusted air
shutter.
ADDENDUM #2 Class A Chimney Conversion Kit
Simpson Duravent provides a conversion kit for those wishing to use
an existing wood stove chimney to vent this direct vent stove. The
illustration below gives an overview of this type of installation. See
the instructions included with the kit for details.
! The conversion kit does not work on interior masonry chimneys.
! Do not exceed the maximum vertical rise (see the section
"Approved Vent Configurations" starting on page 9) allowable.
Remember to set the restrictor position to the correct position
(based upon the vertical rise height - see the chart on page 10).
Chimney Conversion Kit A (# 931)
Metalbestos 6" (150 mm) I.D.
Security Chimneys 6" (150 mm) I.D.
Jackes-Evans 6" (150 mm) I.D.
Hart & Cooley 6" (150 mm) I.D.
Pro-Jet 6" (150 mm) I.D.
Chimney Conversion Kit B (# 932)
Simpson Dura-Vent 6"(150 mm) I.D.
Air-Jet 6" (150 mm) I.D.
Metal-Fab 6" (150 mm) and 7" (175 mm) I.D.
Amer. Metals 6" (150 mm) & 7" (175 mm) I.D.
Metalbestos 7" (175 mm) and 8" (200 mm) I.D.
Jackes-Evans 7" (175 mm) and 8" (200 mm) I.D.
Hart & Cooley 7" (175 mm) and 8" (200 mm) I.D.
Pro-Jet 7" (175 mm) and 8" (200 mm) I.D.
Security Chimneys 8" (200 mm) I.D.
Chimney Conversion Kit C (# 933)
Simpson Dura-Vent 7" (175 mm) and 8" (200 mm) I.D.
American Metals 8" (200 mm) I.D.
Air-Jet 8" (200 mm) I.D.
Metal-Fab 8" (200 mm) I.D.
American Metals 8" (200 mm) I.D.
Each Kit Contains:
Retro Connector
Retro Vertical Top
Additional Equipment:
4" Flex (#711 or U.L. 1777)
Termination (#991)
Co-Axial Sections
Screw the Retro
Vertical Top to the
Flex Pipe
Type A Chimney
4" Aluminum
Flex Pipe
Retro Connector
(screw to chimney)
Simpson Duravent Direct
Vent Pipe Sections
(use adjustable section)
Retro Vertical Top
(screw to chimney)
Cut the Flex Pipe
to the chimney
height plus 3"
Screw the Retro
Connector to the
Flex Pipe