Machine Operation (Scrubbing/Drying) - Nilfisk-ALTO SCRUBTEC 545B User Manual

ENGLISH

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. If necessary, press the washing water fl ow control switches (82) as necessary, depending on the type of cleaning to be
performed.
3. If necessary, stop the machine and turn the squeegee adjusting handwheel (27) so that the rear blade - in all its length -
touches the fl oor.
4. If necessary, stop the machine and turn the adjusting handwheel (28); when turning it clockwise or counter-clockwise the
machine forward speed can be adjusted.
5. If necessary, stop the machine and turn the machine forward speed adjusting handwheel (29) (only for SCRUBTEC 545B and
553B) as shown below:
• Turn it counter-clockwise to increase the forward speed;
• Turn it clockwise to decrease the forward speed.
NOTE
For correct scrubbing/drying of fl oors at the sides of the walls, Nilfi sk Alto suggests to go near the walls with the right side
of the machine as shown in fi gure 3.
CAUTION!
To avoid any damage to the fl oor surface, turn off the brush/pad-holder when the machine stops in one place,
especially when the extra pressure function is on.
18
USER MANUAL
A
SCRUBTEC 545B – 545BL – 553B – 553BL – BOOST 5
Figure 3
B
9097054000(2)2009-06 A
P100106A