Iberital 2 Groups Instruction And Operation Manual page 11

If during the adjustment of a dosing any of the LEDs are winking, the adjustment will not be
memorized. Please check the volumetric counter, in case there would be any dust from the water
supply.
III. ADJUSTMENT OF THE ELECTRONIC PRE-INFUSION
(FOR THE IBERITAL WITHOUT DISPLAY MODEL ONLY)
The pre-infusion can be enable and disable, as follows:
To enable this function:
1) Turn Off (position 0) the On-Off switch
2) Press the 1 short coffee (espresso) button of the left group (group 1) and at the same time
turn On the On-Off switch (to position 1 or 2).
3) The 1 short coffee (espresso) LED will light
4) Stop pressing the 1 short coffee (espresso) button
5) Turn Off (position 0) the On-Off switch
6) Finally, turn On the On-Off switch to the position 2 (normal working).
To disable this function:
1) Turn Off (position 0) the On-Off switch
2) Press the 1 long coffee button and at the same time turn On the On-Off switch (to position 1
or 2)
3) The 1 long coffee LED will light
4) Stop pressing the 1 long coffee button
5) Turn Off (position 0) the On-Off switch
6) Finally, turn On the On-Off switch to the position 2 (normal working)
IV. ALARM-WARNING SIGNALS
•
Boiler fill up exceeding time
The probe warning signal starts after 1 minute without being in contact with water. The alarm signal is:
winking all the touch path LEDs.
This alarm is due to a leak of water in the machine or the touch path is not sending any signal to the
auto fill up system.
Important: when you are doing the water fill up of the boiler process for the first time and this alarm
appears. Then, turn the On-Off switch Off (position 0) and following turn the On-Off switch On
(position 1) another time. (The fill up process takes more than 1 minute).
Página 9 de 30
IBERITAL DE RECAMBIOS, S.A.
MANUAL NEW IBERITALINGLES
11/05/2007