Pet Handimate Maintenance - Kenmore 592.30414 Use & Care Manual

PET HANDIMATE MAINTENANCE

TO REPLACE BRUSHROLL
1. If a clog is present or debris is visible,
unscrew the two screws on the back
of the pet handimate to remove the
faceplate and clear any obstructions.
2. Inspect condition of brushroll.
Replace brushroll if brushes are
worn down. To remove brushroll,
pull up and out of end slots in nozzle
housing. Insert ends of brushroll into
same slots to replace.
Note : Inspect belt to ensure that it
is in good condition. If belt is
broken or cracked, replace belt
according to To Replace Belt
instructions.
3. Insert the four tabs on edge of
bottom plate into slots on fronts of the
faceplate. Pivot faceplate down and
secure with two screws.
TABLE OF CONTENTS
TO REPLACE BELT
1. Remove bottom plate. See figure in
2. Loop one end of new belt around
3. Loop other end of belt around
4. Fit Pet Handimate back together as
17
To Replace Brushroll instructions.
shaft of pulley.
designated area for it on brushroll.
Insert brushroll into slots in nozzle
housing. See figure in To Replace
Brushroll instructions.
described in To Replace Brushroll
instructions.