Assembly Instructions - Kenmore 592.30413 Use & Care Manual

Please pay special attention to these hazard alert boxes, and follow any
instructions given. WARNING statements alert you to such dangers as fire,
electric shock, burns and personal injury. CAUTION statements alert you to
such dangerous personal injury and/or property damage.
WARNING
Electrical Shock Hazard
Do not plug into the electrical
supply until the assembly is
complete. Failure to do so could
result in electrical shock or injury.
HANDLE ASSEMBLY
assemble Accessory Holder
1. Stand the vacuum upright and slide
the base of the handle firmly into the
grooves at the top of the vacuum
body.
2. Check to be sure the handle is fitted
to the vacuum body. If there is a gap,
continue to push firmly until the handle
is flush.
3. Tighten securely with a screwdriver.
DJ68-00514A-00.indd 7

ASSEMBLY INSTRUCTIONS

Accessory Holder
25mm screws
(2EA) to assemble
Handle
16mm screw (1EA) to
CAUTION
Do not overtighten.
Overtightening could strip the screw
holes.
Do not operate the vacuum cleaner
without the screws in place.
ACCESSORY ASSEMBLY
1. Attach the accessory holder by lining
up the tab on the base with the
corresponding notch on the back
of the vacuum and insert a 16mm
screw provided from the bag with an
accessory holder into the existing hole.
Tighten securely with a screwdriver.
2. Place the extension wand and
the crevice tool together into the
accessory holder right side.
3. Place the combination tool into the
accessory holder left side as shown.
3
1
7
2
2009.8.22 9:19:20 AM